Computron Medical completely remanufactures each C-Arm to meet or exceed original
equipment manufacturer's specifications. Many of the components are new and state-of-the-art.
- New Image Intensifier (the most important component in terms of image quality and cost)
- I.I. power supply calibrated
- New rotating anode x-ray tube
- New high resolution Vidicon camera tube - high sensitivity (high sensitivity - gives a better image at a lower dose)
- New batteries
- Digital system calibrated
- Video system calibrated
- X-ray system calibrated
- New upgraded high voltage cables
- New upgraded interconnect cable
- New upgraded interconnect connectors
- New grid 8:1 (promotes higher quality images)
- New grid ring
- Switches and circuit breakers replaced as necessary (helps to prevent intermittent failures)
- New upgraded higher-load rated wheel bearings
- New upgraded C-Arm wheels (makes the C-Arm easier to move)
- New monitor cart wheels (makes the cart easier to move)
- New upgraded footswitch, cables, and connectors
- New air filter for monitor cart
- New hospital grade power cord
- New hospital grade plugs and connectors
- New wig/wag and pin
- New monitor cart control panel
- New monitor cart patient annotation keyboard
- New paint
- Parts chromed
- Vertical drive assembly checked and adjusted
- Hardcopy camera installed and calibrated (if ordered)
- Monitor CRT's replaced.
- Power supplies recalibrated or replaced
- Upgraded firmware (increases system uptime)
- Collimator bearings checked and replaced if necessary
- Safety bulletins performed (this is absolutely necessary regardless of vendor)
- Field service bulletins performed (most systems in the field have not had all FSB done)
- System burned-in for 48 hours prior to delivery (helps to locate problems before the system is shipped)
|
